Had quite a few runners too. The lowest-priced brand-new, unused, unopened, undamaged item in its original packaging where packaging is applicable. This humiliation is worse than dying. So possible na mas appropriate yung solution na change lang sila gn location. I will try to answer them to the best of my ability. I would like to apologize for the wrong post on my first article of The Poisoned.
Long, sharp, and could be a bit heavy for its wrist at certain angles. Visit the address below to see what I am building right now. Boomerangs just plug straight into the end of each shoulder. But I eventually realized that meant it was too loose to hold the wings up, so I started tightening them again with super glue gel. The wings of light alone are definitely worth getting the Extreme Blast Mode for! I took some 1000 grit sandpaper to remove the frosted parts off the wings large surface area so it came out clean while I used alcohol to clean smaller parts like the shoulders and beam rifle. The effects parts fits well on the rifles.
The joints are stiff and the armour separation on the legs are amazing! Still, Destiny looks gorgeous with the wings on. Keep it classy or face mod action. One bit that surprised me after assembly was that the whole wing cannot rotate up or down when closed… well, nor when it is opened for that matter. The effect part of the Beam Saber is slightly curved. Weel, same naman halos price nila dun sa Divi pero not sure ako if nagbago na. The Kit also suffered from some back heavy issues.
You could just search up the images and compare from there. Get it or not depends on what you think is worth it. We shall start with articulation for this kit: And finally the peg that joins the wings to the jetpack can be pulled out abit for further articulation! The cannon is supposed to dislodge from the rear rack so Destiny can wield it freely but that can only happen in the anime. Also dont count on those wire mounts for your dragoons to the base those dont come with it the pictures are misleading. I do make some mistake when spray painting this kit as a result some parts will have some minor stains of paint on it which is unintended. First of all, let me be clear that there won't be any WoL or Wings of Light im confused which one uses the Wing of the Skies term. I can't blame him if he's English isn't good since mine isn't that good either.
Thanks to my co-builders, colleagues, and friends who shared a lot of news about this kit. On both wings this center joint not only needs to open the wings but also needs to raise the wings. The overall height of the figure was about 19cm. Note the difference in color between the silver plated parts and the cream gray. As a result, I have to use cement and dissolved putty to cover the crack and reattached the part that broke off. Spent 12 bucks on ebay for a effect kit for my master grade strike freedom and it was cheaper and even came with mounts to help secure the parts in the wings.
I also screwed up the topcoating process for this model; some of the parts frosted up when I was spraying in cold rainy weather outside. Gotta be sure to show off the wings too! I also tried the follow the bending degree of the plastic rod recommended by Bandai. This irritation faded until I got to the final part of this kit the inner part of the wings where it came back in force. Overall this kit can be quite expensive and the wings of lights attachment will further ramp up the money the spent on this kit. Show us how weak you really are! Not only that, it also scratches the hell out of the side of the red section of the body if you look at the design, the side skirts go high up to the body; you can see the scratches on the topcoat in many of the photos and the skirts are turned sideways so you have to turn them sideways if you want to spread the legs wider than normal.
Hmm~ Final thoughts: Well This kit was definitely interesting to build. I drilled a hole a little over 2mm in diameter through it, inserted a brass tube, glued it in place with epoxy glue, and finally filled in every gap with epoxy putty. Yes I did not pose him with his beam rifle since. The anime featured a lot of well- designed Gundams and the Strike Freedom happened to one of my favourite Gundam featured in the series. However, Some inner frames were not gold plated. Completion of the kit Pardon my low quality Image, I do not have a good camera at that time The images above shows overall look of the kit after completion.
I also painted the dragoons and some of the outer frame of the kit with the Gold marker to make the kit more detailed. For me though the real first disappointing issue was the seam lines. The acrylic rods does not have the have the ability to bend like the rods provided by Bandai. The wings of light certainly add to the aesthetic that I think one would be able to appreaciate more in person. Di kagaya sa Momoko, lumamang sila dahil parang mechanical rods yun. Each and every piece of armor was not only extremely tight but also had long as hell pegs for no conceivable reason.
As you can pretty much see, the articulation on this model is top notch! Needs some light… Wings of Light The pair of translucent wings are connected through these clear connectors that goes under the top and bottom wings. Since he is Malaysian, there's some parts of his phrases that can be misunderstood. I also did some minor filing and sanding in order to fit the Dragoons onto the acrylic rods. Putting a layer of paint or coating on the torso inner frame should solve this problem — Not all the inner frame are gold plated — The plastics rods used to support the Dragoons may loose strength overtime. Again thank you and more power.